Qingdao Futai, Air Compressor Filter Manufacturer in China.
|Place of Origin:
|Minimum Order Quantity:
|Carton, Wooden cases, Plastic bag, etc, make the package as your requirement.
|Screw Air Compressor
Fusheng Alternative Air Oil Separator,
ISO 9001 Air Oil Separator
FuSheng Alternative 2116010157 Screw Compressor Air Oil Separator
Screw air compressor oil separator run oil failure analysis and solution:
If oil return valve damage (from ChanXiangTong to two-way communication), oil tank pressure after downtime will pour a large amount of oil through the return pipe to oil content inside, the next machine is running, oil inside the oil will not be able to timely sucked back into the nose, causing part of the oil with air to air compressor of the separated closed oil cut-off valve (this kind of situation is common in not device and machine head exhaust outlet check valve).
Solution: check the check valve after removal, if there is debris to jam it, clean up the debris, such as the check valve has been damaged, then replace the new product.
When replacing, cleaning and maintaining the air compressor, the return pipe is not inserted into the bottom of the oil (reference: it is better to be 1~2mm away from the arc center of the bottom of the oil), which leads to the separation of the oil can not return to the head in time, and the accumulated oil will run out with the compressed air.
Solution: stop the machine, after the relief pressure returns to zero, adjust the return oil pipe to a reasonable height (the return oil pipe is 1~2mm away from the bottom of the oil part, the inclined return oil pipe can be inserted into the bottom of the oil part.
Solution: it is recommended to contact the manufacturer to replace an oil product that can match the low pressure.
When the return oil pipe (including the one-way valve on the return oil pipe and the return oil filter) is blocked by foreign bodies, the oil condensed at the bottom of the oil after separation cannot return to the head, and the condensed oil drops are blown up by the air flow, and are taken away with the air after separation.These foreign bodies are usually caused by solid impurities that fall off during installation.
Solution: stop the machine, and remove all pipe fittings of the return oil pipe after the pressure of the oil barrel is relieved to zero, and blow out the blocked foreign body.When installing the built-in oil separator, pay attention to clean the oil and gas barrel cover, and pay attention to whether there are solid particles at the bottom of the oil separator core.
|Air compressor Model
|Air compressor Model
Oil Separator 2116010157
Contact Person: Xu