6.3559.0 Screw Compressor Air Oil Separator 0.02Mpa

High Quality Oil Separator 6.3559.0 Screw Compressor Air Oil Separator

Fault analysis and solution of oil running of screw air compressor oil separator:

• Oil return check valve is damaged

           If oil return valve damage (from ChanXiangTong to two-way communication), oil tank pressure after downtime will pour a large amount of oil through the return pipe to oil content inside, the next machine is running, oil inside the oil will not be able to timely sucked back into the nose, causing part of the oil with air to air compressor of the separated closed oil cut-off valve (this kind of situation is common in not device and machine head exhaust outlet check valve).

          Solution: check the check valve after removal, if there is debris to jam it, clean up the debris, such as the check valve has been damaged, then replace the new product.

• Improper installation of the return oil pipe

         When replacing, cleaning and maintaining the air compressor, the return pipe is not inserted into the bottom of the oil (reference: it is better to be 1~2mm away from the arc center of the bottom of the oil), which leads to the separation of the oil can not return to the head in time, and the accumulated oil will run out with the compressed air.

          Solution: stop the machine, after the relief pressure returns to zero, adjust the return oil pipe to a reasonable height (the return oil pipe is 1~2mm away from the bottom of the oil part, the inclined return oil pipe can be inserted into the bottom of the oil part.

•  Large gas consumption, excessive load and low pressure use (or the oil processing capacity selected before the machine leaves the  factory matches the exhaust volume of the machine too tightly) load and low pressure use refers to that when the user uses the air compressor, the exhaust pressure does not reach the rated working pressure of the air compressor itself, but it can basically meet the gas requirements of some enterprise users.

           Solution: it is recommended to contact the manufacturer to replace an oil product that can match the low pressure.

• The return oil pipe is blocked

           When the return oil pipe (including the one-way valve on the return oil pipe and the return oil filter) is blocked by foreign bodies, the oil condensed at the bottom of the oil after separation cannot return to the head, and the condensed oil drops are blown up by the air flow, and are taken away with the air after separation.These foreign bodies are usually caused by solid impurities that fall off during installation.

         Solution: stop the machine, and remove all pipe fittings of the return oil pipe after the pressure of the oil barrel is relieved to zero, and blow out the blocked foreign body.When installing the built-in oil separator, pay attention to clean the oil and gas barrel cover, and pay attention to whether there are solid particles at the bottom of the oil separator core

Product Description

AIR OIL SEPARATOR 

Main products:

Filters:air filter ,oil filter,oil separator ,filter element (line filter).

Services kits: unloading valve kits, Minimum pressure valve kit,Stop oil valve kit, check valve kit,thermostat valve kit and so on.

Valve assembly:air intake valve, thermostat valve, solenoid valve, minimum pressure valve kit,blow off valve, drain valve and more.

Rubber parts: hose, coupling, elbow, anti-vibration pad, housing, belt.

Sensor: temperature sensor, pressure sensor, oil level sensor.

Other parts: gear wheel, controller, temperature switch, pressure switch, cooler ,cleaning agent.

oils: mineral oil, semi- synthetic oil.