1089062109 Solenoid Valve For ATLAS COPCO Air Compressor Valves

Solenoid valve failure will directly affect the switch valve and regulating valve action, common faults have solenoid valve does not act, should be investigated from the following aspects: 

• Solenoid valve wiring loose or wire off, the solenoid valve is not electric, can tighten the wire.Solenoid valves are widely used in our production, we in the maintenance of production must have met a lot of questions about the solenoid valve, also deal with all kinds of fault, we also must have accumulated a lot of experience regarding the handling of electromagnetic valve failure, and I in the maintenance treatment solenoid valve failure relative to other instrument control failure is relatively small, and now I was with you on this question discussion, eager to learn from you more experience and improve together.

• The solenoid valve coil is burnt out, the wiring of the solenoid valve can be removed and measured with a multimeter. If the circuit is open, the solenoid valve coil is burnt out.The reason is that the coil is damp, causing bad insulation and magnetic leakage, causing the coil current is too large and burned out, so we should prevent rain from entering the solenoid valve.In addition, the spring is strong, the reaction force is too large, the coil turns are too few, the suction is not enough can also make the coil burned.In case of emergency, the manual button on the coil can be hit from "0" to "1" in normal operation to make the valve open.                                         

• Solenoid valve is stuck.Solenoid valve sleeve and spool with very small clearance (less than 0.008mm), are generally a single assembly, when there are mechanical impurities into or too little lubricating oil, it is easy to get stuck.The treatment method can be used from the head hole poke into the steel wire, so that it bounced back.The fundamental solution is to remove the solenoid valve, remove the spool and spool sleeve, with CCI4 cleaning, so that the spool in the sleeve of flexible action.When disassembling, attention should be paid to the assembly sequence and external wiring position of each component, so as to reassemble and connect correctly. Also, check whether the oil spray hole is blocked and whether the lubricating oil is sufficient.

Main products:

• Services Kits: Unloading Valve Kits, Unloader Valve Kit, MPV Kit, Stop Oil Valve Kit, Check Valve Kit, Thermostat Valve Kit and so on.

• Valve Assembly:Air Intake valve, Thermostat Valve, Solenoid Valve, Mminimum Pressure Valve, Blow Off Valve, Drain Valve and so on.

• Rubber Parts: Hose, Coupling, Elbow, Anti-Vibration Pad, Belt and so on.

• Sensor: Temperature Sensor, Pressure Sensor, Oil Level Sensor.

• Other Parts: Gear Set, Oil Seal, Shaft Sleeve, Spring, Controller, Oils and so on.